Dynamic Balancing

May 13 - 15, 2008

Chad Wilcox will be teaching a Dynamic Balancing course in Fort Collins, CO May 13th to the 15th, 2008. Students who attend this course will learn how to properly diagnosis unbalance and perform single-plane and two-plane field balancing. Attendees will learn how to approach balancing for multiple rotor configurations and numerous tried and true balancing tips. Students will also be introduced to the necessary balancing standards to become a reputable balancer.

The class is $900 for the 3 days of training. Pioneer Engineering's Dynamic Balancing text is included as are lunches. Students should bring their portable analyzers (regardless of manufacturer) for hands on use during the course. If you don't have an analyzer Pioneer Engineering's VIBXPERT ® will be on hand for use.

Contact Chad Wilcox via email at cwilcox@pioneer-engineering.com or by phone at (970) 266-9005 to register. A syllabus of the course can be viewed here.

 

Public Seminar Dates Announced for 2008

January 15, 2008

Pioneer Engineering has set dates for the 2008 public seminar schedule. If a course you are interested in is not listed below please contact us. Please click on the seminar title you're interested in for more details and a course syllabus. Seminars will be held in Fort Collins, Colorado.

February 4-8, 2008 -

Intermediate Applied Vibration Analysis

 

April 7-10, 2008 -

Introduction to Applied Vibration Analysis

 

May 13 - 15 , 2008 -

Dynamic Balancing

 

August 11-14, 2008 -

Introduction to Applied Vibration Analysis

 

September 16, 2008 -

Root Cause Failure Analysis

 

October 6-10, 2008 -

Advanced Applied Vibration Analysis

 

November 10-14, 2008 -

Intermediate Applied Vibration Analysis

 

December 8-12, 2008 -

Expert Applied Vibration Analysis

Advanced Applied Vibration Course

October 29th - November 2nd, 2007

Mitch Stansloski will be teaching an Advanced course in Fort Collins, CO. Students who attend this course will be able to select the appropriate machinery vibration analysis technique. Specify the appropriate vibration instrumentation hardware and software for both portable and permanently installed systems. Establish vibration monitoring programs, including the determination of machines for periodic and continuous monitoring, frequency of testing, route plans. Perform single plane field balancing. Measure and perform diagnosis of single-channel frequency spectra, as well as time domain plots such as waveforms and orbits, under both steady-state and unsteady operating conditions, with or without a phase trigger, and much more. There will be an ISO Category III Cert. test given to those students who would like to continue or become certified with the Vibration Institute. Contact us for details on how to register. Click here to view the syllabus.

Intermediate Applied Vibration Course

October 15th - 19th, 2007

Seth Gregg will be teaching an Intermediate course in Baton Rouge, LA. October 15th - 19th. Students who attend this course will be able to select the appropriate machinery vibration measurement technique. Maintain a datbase of results and trends. Establish and implement general overall level alarms. Set up instruments for the basic resolution of amplitude, frequency & time. Perform basic vibration analysis of machinery & components, such as shafs, bearings, gears, fans, pumps & motors, using spectrum analysis. There will be an ISO level II Cert. test given to those students who would like to continue or become certified with the Vibration Institute. Contact us for details on how to register. Click here to view the syllabus.

Pioneer Engineering is partnering with Ludeca

July 2007

News Image Caption

Pioneer Engineering is partnering with Ludeca and adding remote condition monitoring services for nearly any application.

Contact Chad Wilcox via email at cwilcox@pioneer-engineering.com or by phone at (970) 266-9005 to find out more.

To find out more about any of the condition monitoring and alignment products offered by Ludeca visit www.ludeca.com.